Watlow Series V4T Manuale Utente Scaricare il pdf (Pagina 4)

Watlow Series V4 4

Installation and Removal (continued)

Figure 4a - Slightly compress the case while Figure 4b - Snap the top and bottom mounting

pulling the controller into the panel cutout. bracket into the slots.

Figure 4c - Tighten screw to secure the controller. Figure 4d - Remove the controller using a flat

screwdriver.

NOTE: Be careful not to over-tighten the screws. This may cause the mounting cover to fail. Over-tighten-

ing occurs when the front bezel is touching the customer’s front panel.

Removing the Series V4 Controller

1. Loosen the upper and lower mounting bracket screws.

2. Use a flat screw driver to unsnap the four grips on the opposite side of upper and lower mounting

brackets. Push the brackets back and forth gently until they can be pulled off easily.

3. Remove controller from the panel.

1 2 3 4 5 6 7 8 9 ... 25 26

Nessun commento

Watlow Series V4T Manuale Utente Pagina 4